Questions & Answers for: replace pcm buick lesabre

Buick LeSabre I have a Bosch replacement, not original, so the colors do not match. and need to splice wires to the original plug. black is usually power and if there is a blue its the feedback to the

buick lesa b re It is located in the Passenger Compartment(inside vehicle), Lower RH Front Corner REMOVE OR DISCONNECT Disable Supplemental Inflatable Restraint (SIR) system. Powertrain Control Module

...behind glove compartment cavity. There really isn't any way to fix the PCM, they are ususally

...the car, all the lights and radio and the heater lights start flashing and clicking. I have replaced the starter and the battery. it does not turn the engine over. sounds like a pcm fault

...buick lesabre problems 97 LeSabre won't start,starter is fine, battery good,replaced crank position sensor, can short the starter out and it will run about 60 seconds. Will it only crank with the ...

...replace with used or new pcm ? has to be programed . Important:: Replacement PCM must be programmed. Refer to Powertrain Control Module Replacement/Programming In 95 they used UART serial data pin 9 ...

coil or modual or both fail. Replace them and have one fail in less than 6 weeks. Might be the pcm. It's the only thing that controls it. Check wiring first to make sure that there are no shorts it it

buick lesabre ltd...diagnostic code P0140..what parts are needed to turn off check engine light for inspection? Before replacing a part diagnostic's for code P0140 need to be done . May not be a part

...buick lesabre cranks but won't start Replaced fuel pump, fuel filter and uper intake. Have spark and fuel. But when I pull the plugs they are saturated in fuel. low engine compression could be the ...

...Buick LeSabre 3.8L engine Replaced Ignition Control Module, Engine Control Module (ECM/PCM), camshaft sensor, and crankshaft sensor. Any ideas? Did you have it on a scanner or just replaced parts? A ...