Questions & Answers for: replace an oil pressure switch

...read gauge , idle pressure must be at or above 15 psi, if ok replace oil sender switch, if no pressure check oil pump relief valve for stuck piston or broken spring. Do not drive in this

Ad

...oil pump. Replace the oil pressure switch, you can pick this oil pressure switch at Auto Zone and they can give you the step by step instructions to replacing the switch runs around $10.00. Note do ...

Ad

...replace the oil pressure switch. 3.Incorrect or malfunctioning oil pressure gauge -- replace the oil pressure gauge. 4.Improper oil viscosity or diluted oil Install oil of proper viscosity for ...

...replace the oil pressure sensor: TestingTurn ignition ON (engine off ). Verify if the oil warning lamp lights. turn ignition off. Check the engine oil level. Adjust as necessary. If engine oil level ...

...oil pressure drops when warmed up oil pressure switch was replaced still have same prblem light comes on at idle and goes off when engine speed is increased Hook up a manual oil pressure guage and ...

Question about 1992 Golf

1 Answer

...oil pressure switch http://www.clarks-garage.com/shop-manual/elect-19.htm Replace pressure switch as the cheapest means of repair to see if the lights go out . The pressure switch will be located on ...

Question about 2001 Escape

2 Answers

...switch, and fit a pressure gauge screwed into the oil pressure switch housing. start engine and check pressure ,around 10 PSI at idle is ok, If all checks out OK ,replace the oil pressure

...filter blocked , oil filter relief valve stuck open, oil pressure switch faulty. Best to remove oil pressure switch and fit a oil pressure gauge to get a true reading. If OK just replace the

Question about 2003 Escape

1 Answer

...to the left of the oil filter housing,on the 3.0 liter. If your oil pressure gauge is reading inaccurately,you need to replace the oil pressure sensor instead.Its located near the ac

oil pressure switch, you can replace it if it is faulty or damaged. It is important to ensure that the engine is not running and that the oil has cooled down before attempting to replace the switch to

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...