...glove box with some noise I turned off the AC and pulled over I from that point had no smoke or noise but I also had no AC Fan Heat or Defrost no Venting Fan I think this is a Burned up Blower moter ...
...or blower speed variable module... sounds like time to replace this.. usually mounted in passenger compartment behind glove box area... some are mounted under hood in passenger area near
...replace the Cabin Air filter? To change the cabin air filter one needs to remove the glove box first. This is reasonably simple and involves a couple of screws, the rubber glove box limit pads, and a ...
...the resistor open your glove box and roll it all the down take off the panel in behind the resistor will be top right hand side.This should help.Thanks.Helpmech. reostate is faulty you need new ...
...box end wrench. Inspect the wire lead for melted insulation and discolored insulation. Either condition will require you to replace the wire lead. Make sure the engine has cooled enough to prevent ...
...replace the cabin air filter on my 2003 Hyundai 2.7 V6, Can you help? On the 2003 Santa Fe the filter is located in the air box behine the glove box. You'll have to remove the glove box to get to ...
...glove box with some noise I turned off the AC and pulled over I from that point had no smoke or noise but I also had no AC Fan Heat or Defrost no Venting Fan I think this is a Burned up Blower moter ...
How do you replace the cabin air filter http://alldatapro.com/alldata/PRO~V247750963~C40368~R0~OD~N/0/101825161/106012507/106012508/110695770/34853741/3486 may have to remove the glove box..
Question about 2004 Santa Fe
normal. Any ideas There is a blower control resistor (manual system) or a blower transistor (automatic temp system) located behind the glove compartment in the HVAC box and this is a high failure item
Usually answered in minutes!
1,503 Questions
1,043 Questions
1,001 Questions
881 Questions
417 Questions