Questions & Answers for: NAD replace fuse

NAD L40 My tuner just stopped working on the unit.I have tried using my other receivers arial but still no luck.Upon opening the unit I discovered two blown fuses,I replaced both (with exact same) ...

...supply PCB for leakage, but also check (replace) R401 (2R2) and R402 (2R2) on the main power supply PCB. Both resistors are fuse-resistors and will have gone open circuit when C501 has gone

Receiver fuse continuosly blows when replaced and powered up I am having difficulties with my stereo receiver in which the fuse blows every time I have replaced it. I even uplug the amp in the case ...

...replace that fuse with exactly its type and rating. DO NOT jumper over the fuse, or wrap foil around it. It is EXTREMELY rare for a CD player to blow a fuse unless there is a very serious failure ...

...Replace fuse and power up. If fuse blows check bridge in the power supply. 80% of the time output transistor burn and blow the fuse. before replacing output transistors check driver transistors they ...

...supply PCB for leakage, but also check (replace) R401 (2R2) and R402 (2R2) on the main power supply PCB. Both resistors are fuse-resistors and will have gone open circuit when C501 has gone

...fuse is located in the driver (FUSE) are. Located as you open the door there will be a (Panel) the fastest way to fix this is to PULL all fuses one by one and find the burnt fuse and replace

...power/protection to green. I heard a pop and then the amp did not work. I removed fuse. OK for fuse replacement because purple capacitors (per your previous NAD C370 trouble-shooting solution). ...

fuses blown audio channels down still down after fuses replaced. Usually indicates bad powersupply. Try replacing.

...fuse behind the Power one of switch. If it is faulty the replace the same.Before connecting the power after replacing the fuse. check the working voltage ...