...replace eoc clock get eoc and overlay the black or white cover for the clock is the overlay if you peel the old one off carefully you can restick it on the new eoc pull the range out and remove the ...
replace EOC? I got a F1 code on my oven. I checked the probe and it is working fine. So I ordered a EOC and installed it. Nothing happened. I thought I installed it wrong. so I removed it and replaced
...Replace EOC (Electronic Oven Control) F2Oven too hot Likely a bad oven temperature sensor (should read 1100 ohms) Possible bad EOC (Electronic Oven Control) F3Oven temperature sensor openReplace oven ...
Question about 92002 / 92004 Kitchen Range
...replace the EOC and put the wires in the correct location and oven still doesn't work. Any suggestions? Thanks Replaced the EOC and reset the breaker. Check for voltage between L1 and neutral if you ...
Question about 30 in. Electric Gallery Series Self-Cleaning Double Wall Oven
...Replace EOC F2 Oven over heat Defective Sensor or EOC F3 Oven Sensor Open Replace Sensor F4 Shorted wire or Sensor locate short and correct it F5 EOC failure Replace EOC F6 EOC failure Replace EOC F7 ...
...code clears it's the touchpad...replace the part with the problem...if touchpad built into EOC replace the EOC. Hope this helps...if you have any other questions please feel free to comment
Question about Spectra JBP78 Electric Kitchen Range
...has found the lock motor switches to be out of sequence or shorted. Test switches and if there is nothing wrong then replace the EOC. both of the error indicates the problem in EOC. Regards
Question about Spectra JBP78 Electric Kitchen Range
...replace the EOC. - The part number for the oven temperature probe is AP3704441 - The part number for the EOC is AP3776874 - The part number for the EOC overlay is AP3778486 Read more: ...
relay board. 3. Replace the EOC.1. Test the harness and connections from EOC connector P16 to oven relay board J2. 2. Replace the oven relay board. 3. Replace the EOC. Hope this help. good luck to you
Question about TGF320 Gas Kitchen Range
...connectors from the EOC to Mini Oven Control Board. Check for 15VDC to Mini Oven Control (red and gray wires). If harness and voltage are good replace Mini Oven Control. If fault returns replace
Usually answered in minutes!
1,163 Questions
465 Questions
395 Questions
390 Questions
353 Questions