...Sensor Senseon? Drying System 8 Automatic Cycles Bulky Items Cycle Adjustable End-of-Cycle Signal Wrinkle Shield? Plus Feature (120 Min.) 5 Temperature Selections Quiet Dry Plus Noise Reduction Dry ...
...door opning, does it "click" as you push it??? if not really push it, pull it, samck it a fewt imes. sometomes i find they hang up and dont function properly. but when i go to replace one it pops out ...
Question about Duet GHW9150P Front Load Washer
Replace the fuse(s) or reset the circuit breaker(s). If the problem continues, call an electrician. Is the correct power supply available? (Electric dryers only) Electric dryers require 240-volt power
...lint screen door. I recommend to clean this sensor properly. if the unit continues to show the error code(sensing), this will confirm that the sensor is damaged, and it must be replaced in this
Question about Duet 7.0 Cu. Ft. Super Capacity Plus Electric Dryer
...door never completely opens just not shut tight and the light comes on in it. When this happens the dryer quits, and it is a continous problem drying one load of clothes. It is like the sensor is ...
...door and remove the screws. Take the bottom panel off and the front panel then the drum out. Give it a good hoovering all over and replace the thermal fuse. DUET DRYER MANUAL Wanna see a video? This ...
...door is mounted to. On the lower right side will be the igniter it looks like thisUse a volt meter and check were it plugs into (not the igniter but were it plugs into) and start the dryer and check ...
Question about LAB2700ML Pedestal Drawer for Duet Washers & Dryers
sensor. ( located inside the dryer door usually) Especially if machine seems to shut down early and clothes are still wet. Test with a meter at room temperature and it should show continuity. A failed
Question about LAB2700ML Pedestal Drawer for Duet Washers & Dryers
...at all,it means your sensor got busted and needs to replace with a new one.then be sure your lid switch activates well while the door of your unit being shut(closed).that`s all,may it helps you a ...
Question about LAB2700ML Pedestal Drawer for Duet Washers & Dryers
...Door beep/showed EE when opened -Inlet thermistor ok. 41kohms (39-41k) - Outlet Thermistor ok. 8.8 k ohm(8.5-10.5) -Moisture sensor ok. It beeps in Diagnostic Mode Continuity between CCU and IU cable ...
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions