Questions & Answers for: replace crank sensor 3 caravan

crank shaft sensor. Van drove fine, has a slight stutter. 3 days after replacing the crank shaft sensor the van stutters and dies within 10 seconds of starting. any ideas? maybe have autozone or equal

...idle air control solenoid next to the air intake tube good. did you relearn the cam and crank sensor after installing them. you need a good scantool to do this. try the iac solenoid first. best of ...

...crank shaft positioning sensor it started idled fine ran for a second and now wont start again before i replaced it it would stars foa a sec not idle but run then die then not start again for about a ...

crank or camshaft sensor. is this van a flex fuel if so it could be: 1. Check the alcohol percentage using a scan tool. 2. If more than 35%, disconnect the battery and rub the cables together to reset

...Replace it 3 times,noise returns after a short time my 2003 grand caravan 3.3l run for 30 then daying and fuel pump making noise you can restart again it run for 2 to 3 min dies again pep boys change ...

...Crank sensor & Cam sensor - replaced. IAC-replaced. PCM-replaced. Throttle body cleaned. O2 sensor-replaced. Truck starts and runs, then intermittedly dies, throw it in neutral and it starts back up. ...

stall after 2 to 3 minutes 3.3L ENGINE SHUT OFF AFTER 1 TO 5 MIN... CAR STARTS RIGHT AWAY. I REPLACED COIL PACK, CRANK POSITION SENSOR AND ECU .. Fuel filter.

bad crank bearings. I would pull a rocker arm cover first. If it is full of sludge, put it back on and drive it till it dies. save money for another car. If it is clean, replace the oil sending sensor

...3 times at different times. But it always started back up. We had just replaced some kind of core where the spark plugs go in. But still nothing. run the fault codes check for crank/cam position ...

...3 sensors-cam, crank and oxygen. Put your hand over the tailpipe and have someone attempt to start it, you should feel pulsing , if not you have a plugged exhaust, it happens! All the