Questions & Answers for: Chevrolet Chevy replace control arm bushings

...control arm bushing i am trying to get instructions on replacing my upper control arm bushings on a 1985 chevy pu the a arms need to be removed, and the bushings pressed in and out , then you will ...

Ad

...wiper blade from my 1983 Chevrolet half ton pickup. The original metal part is to be removed to be replaced with anew metal part that comes compete with the rubber part attached. Flip the arm up off ...

Ad

arm, lower control arm bushings, and greased bearings. can you direct as to what I should do now? this may be a strut or spring or a bearing plate that went bad. if you have 4 wheel drive it may be an

86 chevy C10 pick-up with 305 shut off while driving. appears to be getting gas but not spark. ( could see steam come out of the carboratror when gas pedal was pressed but got no ark when spark plug ...

Question about 1986 Chevy

2 Answers

replace it. How do i take it off and put a new one in.(do i need a ball joint press) 98 Chevy Silverado 1500 jack up the the side with the broken ball joint under the control arm. Remove the axle nut

Question about 1986 Chevy

1 Answer

I have a 1995 chev lumina. It has had the entire rear brakes replaced ( drums) , YET it makes a 'clunking' sound when the brakes are applied. What can it be ? The clunking you hear could very well be ...

Question about 1986 Chevy

3 Answers

replace? the older column shifters can be a problem, look at where the shifter arms hook to the transmission there should be some plastic bushings on the end of each arm that nay be worn out and cause

Question about 1986 Chevy

1 Answer

I have a 1993 bonneville and there was a small pin/spring in it that wouldnt let me turn my key. My grandfather and I took the steering wheel off and took the steering column cover off and removed it.

Question about 1986 Chevy

1 Answer

why rocker arms wont pick up oil in 1969 357 chevrolet I'm not aware of a 357 engine in a '69 Chevy. I'll assume it's a 327. The rocker arms in that engine get their oil from the ...

...replace the power steering gear box in my 1971 Chevy C10 but not sure how to take the old one off In general terms, its fairly easy. You need to disconnect the pitman arm, the steering coupler to the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...