...control arm replace at the same time since the bushings will be new on the passenger rear side and not on the drivers side. Also will should i replace the stabilizer bar on the drivers side even so ...
...If you can find replacement bushings, take the control arm to a machine shop and have them replaced. The bushings are pressed in and you would spend the entire weekend trying to get them out by
...a Lexus compared to a Chevy, but I think that it's worth investigating. Where did you have the control arm bushings replaced? It's most likely the CV joints on one or both sides. Check the CV
control arm i av recently change all front parts an control arm bushing but noise still there. The noise comes mostly wen vehicle is moving slowly, the year of my vehicle is 1999 have you replaced the
...arm. They consist of a long bolt with a series of rubber bushings held on to the lower control arm by a nut. Replace these if they are loose or have any worn parts. They are a major noise ...
replace strut caps with no positive results It could be a few things. The most likely would be weak struts and/or springs. It could also be worn bushings in the control arms or sway bar. It could be a
Question about 2004 RX 330
...Most lower control arms replace maximum 2hours. It's like five hours to do both sides 05 tx330
replace the wheel bearing. Removal & InstallationBefore servicing the vehicle, refer to the Precautions section. Raise and safely support the vehicle. Remove or disconnect the following: Rear tire
Question about 1999 ES 300
...replace the upper control arm, you need to take the weight off the spring and pop the ball joint out of the spindle with a special tool OTC 6297 Ball Joint Separator Then it is bolted in by the 2 ...
Usually answered in minutes!
531 Questions
449 Questions
431 Questions
363 Questions
362 Questions