...71-106 inch lbs. 3. Attach the CMP sensor connector 4.Connect the negative battery cable. 3.0 OHV? Are you getting a code. 50% of the time you need to replace the sensor and the drive assembly for
Question about 2003 Durango
...replace a cam positioning sensor in a 2003 4.7 dodge durango or where can i find a site that will let me print off the directions? Answer picREMOVAL - 4.7L The Camshaft Position Sensor (CMP) on the ...
...CMP) sensor electrical connector. Bolt and CMP sensor. To Install: Install or connect the following: Camshaft position (CMP) sensor and bolt. Torque to: 7 ft. lbs. (10 Nm) CMP sensor electrical ...
...replace the fuse and/or wiring. Carefully connect the test light between CMP harness terminal A and C and verify that the test light illuminates. If not as specified, repair the CMP harness ground ...
...REPLACE CMP sensor. COMPLETE Misfire Monitor Repair Verification Drive Cycle. ---------------------------------------------------------------------------------------------- P1309 - Misfire Monitor ...
...CMP sensor O-ring for wear or damage. If a problem is found, replace the O-ring. Lubricate the new O-ring with engine oil before installing.Install the CMP sensor (1). Important: The CMP sensor bolt ...
...---CMP sensor---ECM Check the wiring and connections and if ok then replace the sensor. Check air gap to the rotor and check that there is no dirt or anything else that can affect the air ...
Question about 2000 Savana
...CMP) sensor electrical connector. Remove the CMP sensor bolt. Remove the CMP sensor. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced. It's under the power ...
...replace a part you may or may not need . Why ? What code ? Does the vehicle run ? There has been a lot of confusion on these vehicles with variable valve timing , mixing up cam sensors with camshaft ...
Question about 2010 PT Cruiser
sensor(CMP) sensor A bank 1--circuit malfunction===causes wiring--- CMP sensor ---ECM code p 0344 refers to CMP sensor A bank 1 --circuit intermittent===causes --wiring --poor connection---CMP sensor
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions