sound before the work. The repair shop says it's caused by the strut's wear (130K miles.) If that is the case why no noise before the repairs? Any ideas? Sounds like the McPherson strut rubbing on the
...wheel. If there is any 'slop' in the wheel, you have a bad balljoint. Which requires professional repair, if only for a new alignment once the work is done. Good Luck! chris I just repaired a 98 ...
sound as the brakes were applied. Tried rotating and balancing the wheels with no positive results. The inner tie rod end was worn out on pass. side. I had a shop fix it and the bill came t0 $230, $40
...sound you hear is coming from the Vauum Brake Booster...Sooner or later the Brake Pedal will get hard, because the seal inside of the Brake Booster is leaking..And the only way to repair it, is , to ...
...sound no clock display only comes up with 530 AM radio station There isn't a way to repair this in your car, it is an expensive dealer repair. I recommend that you obtain a good after market ...
...repair.when i fix the one leaking a defferent one starts This sound like you need the super value pack of o-ring.I bet this gets annoying.Well I think that the first thing that you should do is check ...
...sending unit by screwing out the old and install the new. have the new part in hand before starting repair...cheap ...
1994 Chrysler concorde Ac/HEAT Auto control panel, not working. Is there a way to repair? Sometimes it works sounds like a short behind the unit its self. good luck getting to it. this is ...
...sound like if it was the starter that was bad I use and I'd recommend you register for free at www.autozone.com Once registered you'll have access to repair and shop manuals for virtually any ...
...not be suitable for a DIYer (requires steering wheel puller). You may want to take it to a trusted repair facility and have them repair it for you. The labor is approximately 1.5 hrs at the given ...
Usually answered in minutes!
439 Questions
405 Questions
313 Questions
291 Questions
285 Questions