Questions & Answers for: removing the water pump

removing the belt from the crankshaft and compressor pulleys. Loosen the generator adjusting bolt (1), pivot the generator and remove the water pump/generator drive belt. Remove the crankshaft pulley.

Ad

Question about 2005 Impala

1 Answer

water pump replace what do i have to do to get the bolt out from behind the power steering pulley on a 05 impala with a 3.8? i how there is a trick?? thanks Water Pump Replacement (3.8L) Removal ...

Ad

...water pump in an aztec? Notes Water Pump Replacement Removal Procedure Drain the cooling system until the coolant is below the level of the water pump. Remove the drive belt guard. Loosen the water ...

Question about 1996 Mystique

1 Answer

water pump removal REMOVAL & INSTALLATION 2.0L Engine Disconnect the negative battery cable. CAUTION Never open, service or drain the radiator or cooling system when hot; serious burns can occur ...

...water pump buick rendezvou 2003 cost and do it yourself instructions . can i do it myself concerned with loosening the serpentine belt and needing special tools? 1. Drain the cooling system until the ...

Question about 2002 LeSabre

1 Answer

water pump. 2. Remove the drive belt guard. 3. Loosen the water pump pulley bolts. 4. Remove the drive belt. 5. Remove the water pump pulley bolts. 6. Remove the water pump pulley. 7. Remove the water

...water pump 2003 alero. 3400 engine. Removal & Installation 2.2L Engine To Remove: Disconnect the battery ground cable. If equipped with an automatic transmission, remove the exhaust manifold.. ...

...water pump on Pontiac Aztec? It takes near to 1.5 hours to replace the water pump on Pontiac Aztec. The procedure to replace the water pump is as follows:--- Water Pump Replacement --------- Removal ...

...water pump 2004 GMC Envoy 4.2 liter engine. TO REPLACE WATER PUMP.FIRST YOU HAVE TO DRAIN THE COOLANT SYSTEM. REMOVE AIR INTAKE DUCT AND RESONATOR. REMOVE THE RADIATOR SHROUD AND FAN CLUTCH ASSEMBLY ...

Question about 2006 Solstice

1 Answer

water pump Tools Required J 43651 Water Pump Holding Tool Remove the thermostat housing. Remove the water pump access plate from the front cover. Remove the right hand fender liner. Important: A drain

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...