Questions & Answers for: GMC Jimmy removing the motor cover

motor. Car runs good until you get to operating temperature and then the vehicle shuts down. Have changed coil, module, fuel pump, crank shaft sersor, new egr valve. Gives no engine codes. In side the

motor out of a 96 jimmy and i dont know how to take out mty tranmission Remove the driveshaft, or both if 4x4. Remove the starter and if automatic remove the inspection cover by the starter and unbolt

...motor and wiper transmission have to be accessed. usually by removing a cover or cowl panel. purchasing a repair manual will help greatly in understanding the procedure. it will give clear instuction ...

...motor access cover screws. CAUTION Do not cut any deeper than necessary in order to remove the access cover. Cut through the access cover on the cut line using a sharp utility knife. Disconnect the ...

...motor and remove that cover. then there are small screws holding the fan in that you need to remove then you can pull the old motor out and transfer the wheel to your new motor and reinstall. here a ...

...valve located Look down on the front of the motor just below the upper plenum and just above the timing chain cover. Sometimes removing the air tube from the throttle body will make it easier to

...MOTOR WHILE REMOVING BOLTS.THEN INSTALL NEW WIPER MOTOR AND PUT EVERY THING BACK IN PLACE VISA VERSA. It is located right on the windshield washer reservoir. It looks like a short black cylinder. Pop ...

...motor bolts in you simply put every thing back together the same you took it apart. I hope this helps you out and good luck. u have to remove the inside door cover and u have to brake the screws with ...

how to remove center of dash in 2004 touareg need to get center cover of dash off to see what is making noise inside dash, a/c related no dought No need to remove dash, it's accessible from underneath

...over till TDC marks on crank pulley and timing cover marks line up, fit distributor to motor with rotor pointing to number one distributor cap tower, start and set final timing with timing