Questions & Answers for: Ford Expedition removing the motor cover

Question about 2001 Expedition

1 Answer

...motor how do i get to it you need to remove the wiper arms first. thay must be in the highest position for removal. take your hand and move them to that point then remove the nut cover at the base of ...

Ad

...motor working but the arms have been disengaged. please rate as fixya if this is what you need. Mounting Arm and Pivot Shaft ?Windshield Wiper Removal NOTE: The windshield wiper pivot arms (17526) ...

Ad

motor by removing it (should be a white square box held with 3 screws), and operating the temperature control while watching the motor drive, if the motor is good check the door drive it will probably

...motor (white square box), by removing it and plug it in, and turn the temp knob does the motor turn, if not verify power in the plug and replace motor, if so use an inspection mirror and look at the ...

Question about 2000 Expedition

1 Answer

...you seek out your favorite local shop. removing the dash is not easy, there are alot of screws, some in very difficult places to reach. Testing the motor is easy. I hope this helps, let me

...motor operation. I hope thats helped (remember rated this). The starter is located just in front of the front passenger door and behind the front wheel (also behind frame). It's held on by three ...

Question about 2003 Expedition

1 Answer

...motor solenoid terminal cover.Disconnect the starter motor electrical connections.Remove the starter motor. Remove the stud bolts.Remove the two bolts.Remove the starter.Installation WARNING: When ...

Question about 2000 Expedition

2 Answers

motor is turning the shaft, so you have a fairly easy job of tightening the blade and arm to the shaft. Look at the assembly where the big round bit that drives the arm goes into the body. If it's

...motor cover. Remove the three screws.Pry to release the three tabs.Remove the cover.CAUTION: Carefully remove the blower motor so as not to damage the wheel.Remove the blower motor. Remove the three ...

Question about 2000 Expedition

1 Answer

fuse but it blew again right away. Any thoughts Seized blower motor or wire worn through to earth. Remove the cover to the motor and see if you can turn it by hand If it is stuck then replace the unit

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Expedition
2000 Ford Expedition

2,188 Questions

1999 Ford Expedition
1999 Ford Expedition

1,825 Questions

1998 Ford Expedition
1998 Ford Expedition

1,627 Questions

2003 Ford Expedition
2003 Ford Expedition

1,696 Questions

2001 Ford Expedition
2001 Ford Expedition

1,161 Questions

Manuals & User Guides

Loading...