Questions & Answers for: Chevrolet Silverado 1500 removing the motor cover

...motor insulating cover screws. 3 Disconnect the electrical connector from the blower motor 4 Remove the blower motor insulating cover. 5 Pull the retaining tab down while turning the blower motor ...

...motor insulating cover screws. Remove the blower motor insulating cover. Pull the retaining tab down and rotate blower motor counterclockwise to remove. To Install: Position the blower motor and turn ...

motor it was the pulse circuit board ...remove the cover on the firewall remove the board resolder the connections or replace circuit board. I resoldered the connection points and miy wipers work fine

...motor and removed the nuts holding the seat to floor. When removing seat be careful and mark the location of the tracks. If they are not same the seat will not move correct. You will see long rod the ...

with 2 screws 6mm , take out front screw for cover fam motor ,pull cover down so you can unclip plug that goes into the fan motor . when installing new board plug in fan first then screw in the board

...5.5 millimetter. Once cover is out of the way look by the blower motor and you willl see the resistor the wires plug directly to the blower motor those screws are 5.5. I hope Ive been a help. Thank ...

...motor and remove the cover.You need a 20 torx bit.Pry the module out and replace it per the instructions in the new module box.You can get this part at the dealership.You will need to add sealer to ...

...motor cover. Remove the blower motor. Remove the steering column. Roll back the instrument panel. Refer to IP Carrier Replacement in Instrument Panel, Gauges and Console. Remove the coolant recovery ...

...cover and look for a tan with a black stripe wire,this is the wire that needs to be disconnected with the car running you should hear a difference in the idle.set timing and reconnect wire then check ...

...1.You have to remove the plastic cover on passenger side. Motor is located over the transmission hump. 2. Remove wiring harness plug. 3. Remove 3 hex head screws. You need a small 1/4 socket