Questions & Answers for: Chevrolet Astro removing the motor cover

cover from inside the vehicle you will gain access to the spark plug wires and spark plugs. The spark plug wires come out of the distrubtor cap thats at the rear of the motor, the spark plug wires run

Ad

Question about 1994 Astro

1 Answer

...motor there is a front cover held by a center screw... remove the cover there should be a small computer circuit board... disconect and replace... the cards are known to fail and a new replacement ...

Ad

...if the light dims then its working, remove the cover and check the motor for proper operation by adding 12v to same. check to make sure the window is still the grove and the grove is free from ...

...motor in a 98 chevy astro van Should be under the hood on the passenger's side. 4 screws that hold it in place and one plug. Remove the screws, unplug it, remove it. If for some reason it's under the ...

cover) to repair this part? You could just have a blown fuse but the fuse blew for a reason. There are a few possiblities, I'll try to list them in the most likely order; 1) blower motor speed control

...cover from the blower motor. 8.Remove the cooling tube from the motor. 9.Remove the screws that retain the blower motor to the case. 10.Remove the blower motor from the vehicle. Ensure that the ...

cover on 2000 chevy astor blower motor There is one screw which needs to be removed first! I discovered this the hard way, since it is not visible. This should make it easier to remove and replace the

Question about 1995 Astro

1 Answer

...cover in the blower motor area. Cut the acoustic cover between the 5 clip lands. Retain the piece of the acoustic cover for reassembly. Remove the cooling tube from the motor. Remove the screws that ...

Question about 1995 Astro

2 Answers

...motor in a lot of different vehicles. If you think you'll forget where they go label them. Remove valve cover bolts and pull valve cover off. It will resist a little bit because it's glued ...

removing the two bolts. Remove the blots and then remove the bolts holding in the motor. Be careful not to get your fingers trapped and lower the regulator until it can  be removed from the door.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...