Questions & Answers for: Pontiac removing the motor cover

Question about 2001 Montana

2 Answers

...cover Electrical connections from the starter motor Starter motor mounting bolts Starter motor To install: Install or connect the following: NOTE Before installing the starter motor to the engine, ...

Ad

Question about 1997 Grand Am

1 Answer

...motor cover, make the cut just the thickness of the cover, which is1/ 8 inch (2mm) thick. Cutting deeper than that may damage the cooling tube. For 1992-98 vehicles, partially cut the blower motor ...

Ad

Question about 1998 Grand Prix

2 Answers

...cover. Usually this is just a few small screws and/or small bolts Remove the starter motor mounting bolts. Use care as the starter is relatively heavy. Do not allow it to fall. Take note of any thin ...

Question about 1997 Grand Am

2 Answers

...motor cover, make the cut just the thickness of the cover, which is1/ 8 inch (2mm) thick. Cutting deeper than that may damage the cooling tube. For 1992-98 vehicles, partially cut the blower motor ...

Question about 2003 Grand Am

1 Answer

cover plate Disconnect the electric connector from the motor. Remove the regulator bolts (1, 2, 3). Pivot the regulator (right door clockwise, left door counterclockwise) and slide the assembly out of

Question about 2002 Grand Prix

1 Answer

...cover is removed you will see the blower motor. Unplug the connector and remove the three screws holding it to the HVAC housing. Typically you will need a 5.5mm socket to remove the screws (yes its a ...

...motor and doesn`t need to have the timing cover removed.if it happens to be the dohc motor then your best to have a shop do the job as its not an easy job to dothis should be a (sohc)single overhead ...

...motor crank arm cover and seal.    Remove the wiper motor crank arm from the wiper motor.4.1.    Loosen the wiper motor crank arm screw.4.2.    Tap on the ...

...motor bolts to 47 [n-m] (35 lb ft). Install the torque converter cover. Refer to Torque Converter Cover Replacement in Automatic Transaxle - 4T65-E. Install the starter motor S terminal electrical ...

...motor S terminal nut and electrical lead. Remove the torque converter cover. Refer to Torque Converter Cover Replacement (LA1) in Automatic Transaxle - 4T65-E. Remove the starter motor bolts. Remove ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...