model 150T Ironman Treadmill..motor has gone out and I cannot locate instruction manual..need to adjust belt..can you help http://www.ironmanfitness.com/docs/man/treadmills/man-150t.pdf there is the ...
Question about Fitness Achiever Elliptical Trainer
...motor also sounds like it is struggling. This is usually caused by either a slipping drive belt or a broken front roller/drive pulley. Lower cover must be removed to tighten the drive belt. There are ...
Question about Fitness Achiever Elliptical Trainer
...removing the left side panel but still nothing. Am I doing something wrong? Could there be something blocking the left side? To remove the motor cover (#19 from parts list), you have to remove the ...
It is squeaking. Just remember that the number one cause of failure of the motor controller is high walking belt friction. I always make sense to replace the walking belt when you are replacing the ...
Question about Exerpeutic TF1000 Walk to Fitness Electric Treadmill
my Exerpeutic TF1000 treadmill shows a E2 error, motor will not start. I bought this used in box, there was a note inside "When unpacked treadmill show E2 error, called manufacturer and got a ...
owners manual I ordered and AC adapter because I lost mine in a move and now I cannot figure out where you plug it into the machine We lost ours in a move too! It plugs in near the bottom/front on the
error code e11 hi 1.Check that the LED light flashes on the motor controller while rotating the flywheel, check the connections on the controller and control panel.
how do you lubricate the belt on a treadmill use a good silicon spray. it goes under the walking belt between the belt and deck. spray in a "s" pattern to cover entire area under the belt. this keeps ...
How do I take Crank arm off to gaoin access to belt? if the crank arm is one piece ,it will not be possible to remove it however if you remove the pedal ( lh thread lh side) then you can remove the ...
Question about 220t Motor Control Board Part Number 08-0158
why does my ironman 220t treadmill say si2 and give off a burnt scent after replacing a motor control board? we changed the board and turned on the treadmill, si2 was displayed and it gave off a ...
Usually answered in minutes!
27 Questions
7 Questions
11 Questions
1 Questions
1 Questions