Questions & Answers for: Ford F-150 removing glove box

...glove box and bend the 2 tabs and fold the glove box door down, you will then see a plate with 6 to 8 screws, remove the plate, drain the cooling system, remove the heater hoses and pull the heater ...

...glove box and bend the 2 tabs and fold the glove box door down, you will then see a plate with 6 to 8 screws, remove the plate, drain the cooling system, remove the heater hoses and pull the heater ...

...glove box on passenger side. I did the heater core on mine a couple years back. Yes, you will need to remove the dashboard. The heater core is on the passenger side behind the glove box. It is not ...

150 Remove the glove box. Disconnect the heater core from the heater hoses. Remove the cover behind the glove box held on by 8mm screws. Disconnect the temperature cable. Remove heater core. Good luck

glove box opening. Think it is 4 wires to the resistor. When you remove it, it should be shaped like a credit card, so you will be pulling out for a bit, before removing it. This could be different by

glove box, remove the glove box open excess panel and you will see the core. remove heater hoses and pull core out installation is reverse order. berrydalewolf To remove the hoses, the attachments are

find where it located. 88 ford f150 normally behind the glove box . open the glove box. remove contents. then pull glove box down. you should see a black or red rubber button switch. that is the reset

cover from behind the glove box (no need to open the glove box); Pull the cabin filter straight down (sits vertical behind the glove box inside the housing). Install replacement and reattach the cover

cover from behind the glove box (no need to open the glove box); Pull the cabin filter straight down (sits vertical behind the glove box inside the housing). Install replacement and reattach the cover

...glove box Notice two screws on the inside ceiling of the glove box securing the glove box to the dashboard. Use a flat-head screwdriver to remove these screws. The glove box will now be loose. Wiggle ...