Questions & Answers for: Subaru removing glove box

...glove box that is stuck closed. The hasp for opening the glove box still moves, but does not seem to release the glove box itself. Any ideas as to how to get the glove box open? hello first thing to ...

...glove box and when you lower it, you will notice it is supported on both sides by what look like strings. You can remove these (at the box) and allow the box to flip down. Look straight in and you ...

...glove box. You have to remove the glove box, once you get it out of the way you will need to remove the 4 metal clips that hold it in place and make sure you put the filters in with the arrows ...

...glove box. The first thing you need to do is empty the glove box. (2) you need to remove the side panel that runs along the side of the shifter, it is a long panel and has on clip near the firewall, ...

glove box but don't see how to find it. Thanks Doug Once your glove box is removed and out of the vehicle, you will see the HVAC casing. The access panel held in with 4 clips is what your cabin filter

...glove box. In order to access the cabin filter, first remove the passenger instrument panel side cover. Next, open your glove box and there should be one clip on the left and right side of the glove ...

...glove box. First you will need to remove the glove box. Open the glove box, and on the left and right side on the inside, there will be a retainer that you will need to pull out. This will cause your ...

...air is located behind the glove box. there are about 6-8 phillips screws that secures the glove box. once the box is removed, you will see a rectangular access cover that flips open to the

...like now. I have the glove box out and I can't see how to remove the blower motor. its under the glove box facing up. you remove it by dropping it down. there should be 2-4 screws and the drain ...

...glove box, you will see two connectors held in with screws with wires going to them. The lower connector is the resistor pack. Disconnect the connector, remove the screws and the resistor pack will ...