Questions & Answers for: kawasaki VN 800 Vulcan Classic remove tank

...remove the plug. The stock plug is NGK CR7E. For the tank, after cleaning, get a liquid tank liner and rust will never be an issue again. Google ? kreem fuel tank liner ? or go to ...

OF SPARK & NEW GAS. COULD IT BE THE PLUGS & HOW DO YOU REMOVE. Please check these things before you start taking stuff apart: Gas in Tank? Fuel valve turned on? Kill switch in the Run position

...tank off. Remove the seat single bolt at the rear pull the seat back and off then you will see the rear tank bolts remove them. next To remove the tank there are 3 bolts on the triangle cover on the ...

...to remove the tank. If you remove the speedometer cowl, there is a positive and negative under the cowl. Just tie your wires to these and you will have power. It is in the fuse panel under

...Remove the bolt under the dash on the frame mount and the bolt at the rear of the tank. Lift the tank, and you can disconnect the one or two (CA models) vent lines. Place the tank so that the weight ...

...tank Remove the single screw or nut that holds the speedometer cas to the tank. carefully move the case forward and release from the front or the tand. disconnect the two or three plugs and the ...

...to the motorcycle. One is on the underside of the tank. The other two are on either side of the front bottom of the tank. 4 Push the tank forward and lift to remove it from the body of the

...remove it once more. Engine oil levels should be between the "H" and "L" marks on the dipstick. If not, refill with SAE 10W-40 engine oil. 19 Check coolant levels in the reserve tank by situating the ...

99 vn1500 seat removel Remove two bolts on rear sides. Push down front of seat slightly while lifting rear to disengage bolt from tank fastener at front.

...tank to carb without the engine running because the fuel is pulled by vacuum. Remove line from petcock an have it set to on or reserve position and if fuel comes out it is bad, and let's the fuel ...