...remove sensor from hub? It appears to be stuck & won''t move... WD 4 it? Ron I destroyed one on my Audi that way. What you should do is go at it from the opposite side. Find a way to gain access to ...
stuck on....the ABS comes on the dash intermittantly, could this be 2 seperate things? Brake Light switch and the ABS Sensor(s)? Any Advice? CHECK YOUR FUSES I HAD ONE WITH A BLOWN FUSE CAUSING LIGHTS
...stuck to the magnetic ABS sensor. behind the hub. Remove the sensor from behind the hub and clean it or remove the whole hub. To remove the hub you need to remove the calliper and rotor, knok off the ...
stuck? I know where it is... for reasons that have nothing to do with the ABS system, I need to temporarily remove the sensor from the knuckle. I removed the screw, and the tear drop shaped plate that
...stuck in the steering knuckle requiring a little, or lot, of hammer action to remove it ! If your car is ABS equipped be aware that on some designs part of the ABS sensor can remain stuck inside the ...
Question about 2001 F250 Super Duty Super Cab
Remove the sensor, clean it up and reinstall. If that doesn't work, replace the VSS. You will find it on the top of your rear differential. Side note: If you ever get stuck in the mud/snow and have to
...stuck or need specific instructions for your car, please get back to me with model, year and engine info. If it's a 1997 vehicle, there are many things that cause the ABS light to come on. A simple ...
remove a stuck abs sensor how to remove a stuck abs front wheel sensor Hi Ron,here's a link on your abs senor removal guide and join their site,its so free then you can use their repair guides like me
Question about 2006 Fusion
if the plug came off or a wire is broken. If all is ok with that you may have a ABS sensor that is stuck. You can remove it and clean it off and put a very little grease on it and it should free it up
Question about 2006 Fusion
stuck to them, also if a hub was messed with a bad hub can grind down the ends of the abs sensors. put antiseeze before you put the sensor back in because they can be hard to remove and can get broken
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions