spray head. Pour several pots of clear white vinegar through the unit to further remove lime and scale from the interior of your coffee maker. My Bunn is 24 years old, and the only replacement parts I
...spray head by removing it and at the same time run the cleaning spring up through where the spray head screws to. before replacing spray head place your pot under and pour a pot of water through,to ...
...spray head, remove it, unplug the unit, take it over to a sink and tilt the end that the spray head was on into the sink slowly, the water in the tank will drain out through the spray head pipe until ...
...Remove the spray head and use the spring to clear the water tube (from tank to spray head) if you are handy, remove the top cover and use the spring to clear the hole were the water goes down to the ...
How do you remove the spray head to clean from a BUNN vpr model Use a pair of pliers to remove sprayhead, it should not be in there too tight.
...remove spray head It says to turn the spray head a quarter turn counterclockwise with your fingertips. I have tried everything, even plier, and can't get it off. There is a little tab on the side ...
spray head repair After brewing coffee the unit continues to drip from the spray head. Also it does not use all the water so the pot of coffee is short. I have removed the top and the washer I can see
remove the spray head, clean it and soak it in descaler. reassemble and do a brew. When finished check the surface of the coffee has 6 dimples where the water has poured onto it and that the coffee is
...either of these, remove and clean the spray head. Use a descaling tablet or powder to soak the spray head and then use a small tool to clear the holes. Be careful not to make the holes bigger
Removing spray head Don't know how to remove. Need directions The spray head just unscrews counterclockwise.
Usually answered in minutes!
1,392 Questions
801 Questions
725 Questions
572 Questions
453 Questions