Questions & Answers for: Saturn remove rear wiper arm cap

remove the REAR windshield wiper arm in order to replace the blade. Leonardo There is a clip on the base of the wiper arm that swings out. Then you just lift the wiper arm up and off. Very simple once

...rear wiper arm. This is about 44 bucks at getsaturnparts.net. The problem is getting the old wiper arm off without breaking the rear window. The corrosion between the wiper arm and the motor output ...

...remove the wiper arm assembly there should be a plastic cap lift that under there is a bolt about 12mm or so,loosen and remove,under there you will see a little gear with fine teeth sometimes they ...

...Ion At the end of the wiper arm where it attaches there will be a plastic cap over a nut.Remove the plastic cap and remove the nut and you will be able to remove the wiper arm.I hope this

...wiper arms. Often the female or socket part of the arm has become stripped due to turning the wipers on whilst they are ice/snow stuck to the windshield. Remove the cap at the base of the arm, often ...

...Remove or disconnect the following: Wiper arm retaining nuts and washers Wiper arms Weather-strip at rear of hood Grill nuts from base of wiper arm shaft Grill Electrical harness connector from the ...

...remove the nut which holds the arm onto the little stub. Pull the wiper arm off, may take a little gentle rocking but do not pry against glass. When it is off, put your replacement arm on so that it ...

remove the rear wiper arm and grease the shaft going through the rear window. How do I get the arm off? good luck with that. dealers used to drill a small hole into the base of the wiper arm and drive

remove the wiper arm for replacement. 1.Pry the wiper arm nut cover (located at the base of the wiper arm) off with a small flat-head screwdriver. Remove the wiper arm nut with a metric socket and a 3

...remove the rear wiper assembly from the rear wiper motor I'm trying to remove the complete wiper arm not just the blade so that I can change the wiper motor. flip the nut cover back up the arm and ...