Questions & Answers for: Brother remove rear door cards

...Remove base paper tray: The other flag is at the rear and can be accessed by opening the rear door and then by opening the inner paper exit ***'y you can then see the flag on the exit ***'y,this is ...

remove the rear "door "from the all-in-one (and "carefully" lift the roller guide out of the way. Sometimes a finger works, but a pen is guaranteed to work. When the roller guide is out of the way the

...door on the rear make sure that isn't open. What I would do is Physically open and re-close all doors again the tabs and sensor get sticky after awhile. If not you could have a BAD sensor door

rear door that I don't know about? Sometimes there is a small bit of paper stuck in there, or even a whole sheet, so check for a paper jam there. Always press start after clearing a jam, especially if

...rear door or front and removing toner, or cassette, if it is crumpled in fuser, then it aint easy without pulling it apart, sometimes a manual feed via hand of a pice of stiff card or laminate in ...

...maximum paper path can be check once you remove toner cartridge and if you don?t find any paper in this area check rear door and you may find paper below cover area , paper can be access and ...

..."CLOSE REAR DOOR"? Buy some pants. Hello sir; Check it out the rear door there have a door switch actuator when they close the door the actuat stick the door switch , check it , may be it's

...rear door and make sure it closes flush all around. If this does not clear the message, you may have a broken actuator fin on the door that cannot close the microswitch which makes it think the door ...

...rear door open" door is firmly closed , fax still showing error message ? Look very carefully at the area, Most likly there is a sensor not being flaged. So check for any broken plastic tabs or it ...

...above where you take off the rear jam door?-JM Brother MFC-3240C Error 20 01 Try to take out cartridge and the drum. look inside. Sometimes if you open rear door and look inside and remove the ...