Questions & Answers for: Chevrolet how to remove pin

...differential you first have to remove the pin in the middle of the spider gears.. there is a little 5/16 bolt holding pin in (sometimes the pin breaks you'll need a magnet to remove rest of the

Remove the bolts on the hinges and the bolt from the stay arm. The door can now be lifted off. The existing hinge pins have to be ground off on the underside of the pins before they can be punched out

...pin only. after the trim piece is removed lift the panel up to release it from the window channel Pry off control mechanish with screw driver, pry off small panel next to door handle, pry off two ...

...pin? door pins are available at dealer and part store to change you have to remove the door from truck and change the pins I have changed pins individually without removing the door but it depends on ...

ONE OF THE ENDS OF THAT PIN OPOSIT OF RING GEAR THERES AN 8mm SMALL HEAD BOLT ( TURN RING GEAR TO CHECK OTHER END OF PIN ) REMOVE BOLT PUSH AXLE IN REMOVE HORSE SHOES CLIP IN 3rd MEMBER SLIDE AXLE OUT

how do I remove the rear axle pin to replace the axle seals on a 1998 K2500 the rear center cover must be removed to remove the axle pins. Once the cover is out you can see the houseshoe pins easily

...remove the pin from the door panel . With the pin out of the door panel push the center pin back out of the push pin retainer so it will be ready to go back in)Then remove the screw cover behind the ...

holds the differential pin in. Remove the pin. Push the axle in and remove the C clip. Then pull out the axle. Replace the pin so the spider gears don't fall out if you turn the diff with the axle out

remove pin push axle shaft in so that c clip can fall out with c clip out remove shaft when re installing push axle in all the way put c clip in and pull axle shaft out word and reinstall pin bolt and

...pin popper and i recomend you do it makes the job much eazer, and the tool kit comes with the procdeger to remove the pins, when reinstalling the door replace the pins and bushings they come as a kit ...