Questions & Answers for: Nissan Sentra remove maf

...maf o2 vss and heater circuit sensors. car just started not starting tightenened loose neg cable but just noticed second half of cable where they meet with clip has broken wires help fix the broken ...

...remove all the dirt inside and between the holes.let it dry and install it again.most likely your idle will be stable.im a mechanic and i did those steps on many nissan cars.try it.its a lot cheaper. ...

...maf sensor? i can't figure it out remove the throttle body.use a carburetor cleaner.clean also the stepper motor located beside the throttle body.at your car's mileage,probably its clogged with ...

...MAF and duct. Remove the three screw/bolts from the bottom of the air box, and set the box aside. Disconnect the battery terminals and follow the negative cable to the bolt thru the bellhousing and ...

...Remove the sensor and spray it liberally with the MAF cleaner. Do not use use anything else to scrape or rub any part of the sensor probes. Replace the sensor and then reset the code. Run it for a ...

...MAF sensor. You'll be looking for this component in the air box. Remove the air box cover and pull the air filter out. Loosen the band clamps on the intake tubing with a screwdriver and pull the ...

...maf sensor too, i think 2 probable throubles, one , the catalyc converter clogged , to check remove exhaust pipe section before catalyc and run engine, its very loudness, other is tps fault, tps is ...

...maf sensor and coolant temp sensor and remains on. i've replaced all and also throtle cable, dampner pully, thermostat, and oil changes are on time. everyday it gets louder. ive added fuel treatment ...

...MAF sensor, this is located in the air pipe normally identifiable by a wire coming from a plug into the air pipe system or the throttle body, round metal tubing with black air pipes coming from it. ...

...out all the gas and used clean fuel, no joy 3. Swapped out MAF with known good unit, no joy 4. Removed fuel pump to check if it filter was plugged and pump was ok, no problem 5. Removed ECU ...