Questions & Answers for: Geo Tracker remove maf

96 tracker has no power i have a 96 geo tracker 4 door i just bought cheep. it has a problim that is just out there. when you get it to start it has no power what so ever .after you let it idle a ...

My Geo Tracker runs rough at idle replaced 02 sensor,plugs rotor,cap and wires I started it and it ran OK for a couple of seconds and went right back to running too rich is this because of the air val

iat sensor diagram maf groundthe ok 95 , must be 16v as only that engine has MAF. the sensor is on the air cleaner box, has 2 wires. and the ohms is on the below page. as is the full schematic, and ...

where is the iat sensor located on 1995 geo tracker 93 or 95? 8v or 16valves. ok , here are the facts. all 8v are in the intake manifold just behind the ECT. the 16v is always on the air cleaner box. ...

how to find iat sensor for 1995 geo tracker old post. some dont have it , 92/93 , 16v MPI the 95 does, the 8v is just behind the engine thermostat housing the 16v is in the air cleaner box. both are ...

engine won't stay running unless we unplug MAF sensor Replace maf sensor 2013 , long ago, but the CEL lamp flash codes tell you what failed. unplugging the maf drops ECU to limphome mode. if engine is

diagnostic code p300 poor acceleration, step on gas pedal to take off but vehicle barely move checked diagnostic and code P300 show up means random misfire. (really means weak combustion x4) ever ...

remove MAF and the mimic goes horrid rich. (normal effect) this huge rich hides the true cause of horrid lean. see? 2 wrongs, make a right in this case. its a 97, why are you scan too free. connect it

what is the map senosr location? there is no EFI fuel injection map on that car. the MAP is for the EGR tests ONLY and is smack on top off the Plenum.' the MAF at air cleaner, is used to measure air ...

geo tracker no power after tuneup and filters Starts and idles fine, no power when driving. correct spark plugs. gapped to under hood sticker gap>? (EPA sticker) replace wires 1 by 1 not mixing ...