Questions & Answers for: Ford Focus remove maf

Question about 2001 Focus

1 Answer

...something simple. What I've done: -Checked spark plugs, they are clean and seem okay -Used water remover for fuel tank and injector cleaner, no change -AdvancedAP has checked for any codes and ...

Ad

...outlet pipe. Disconnect the mass air flow (MAF) sensor electrical connector. Remove the MAF sensor. clean element inside carefully PS. A good running engine makes for a better running ...

Ad

Question about 2003 Focus

1 Answer

...air flow (MAF) sensor electrical connector. Remove the MAF sensor. Installation To install, reverse the removal procedure. Otherwise, you may need to adjust idle air control (IAC). report on

Question about 2003 Focus

3 Answers

...MAF which is on the intake pipe with the black box that is screwed down the sensor gets dirty and doesnt read as it should.There is a how to remove and clean on utube with an older mondeo try that ...

...MAF (mass air flow) meter may be faulty, this is typical of the symptoms you are getting. It is just after the air filter in the large bore pipe leading to the inlet on the engine, not a cheap part ...

remove the MAF by disconnecting the hose clamps and screws holding it in place. Make sure to note which side was facing engine because air flow direction is critcal in replacement. Use CRC MAF cleaner

Question about 2000 Focus

1 Answer

...Remove MAF Sensor and spray the tiny heated wires with carb cleaner or MAF sesnor cleaner. ALso, look for air leaks in the air intake system that is allowing unmtered air to bypass the MAF sensor. ...

...Remove the air cleaner housing. Disconnect the mass air flow (MAF) sensor electrical connector.Disconnect the air cleaner outlet hose.Remove the air cleaner housing from the rubber bushing.Disconnect ...

Question about 2000 Focus

1 Answer

...MAF. Also when it tries to start the fan turns on. Battery is good. once the car is running it runs like a top until it sits overnite and the process starts. In order to get it going in the morning, ...

...This could be caused by your Mass Air Flow ( maf ) sensor. It is located on the duct/tube attatched to your air filter. You can remove it and clean it with parts cleaner, dry it and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Focus
2000 Ford Focus

3,749 Questions

2001 Ford Focus
2001 Ford Focus

2,612 Questions

2003 Ford Focus
2003 Ford Focus

2,055 Questions

2005 Ford Focus
2005 Ford Focus

1,226 Questions

2004 Ford Focus
2004 Ford Focus

897 Questions

Manuals & User Guides

Loading...