...MAF sensor all elements are intacked, cleaned it with some non residue electrical cleaner. I also removed the fwd and aft O2 sensor both were clean as could be. Cleaned them anyway with same
...remove the MAF sensor so I can clean it because I have an aftermarket K&N air intake system, and its possible that I may have over oiled it and thus clogged the MAF sensor? the mass air flow ...
...MAF sensor (you'll have to remove any intake tubing to get to it) and clean it. BE VERY CAREFUL to not damage the sensor - don't attempt to wipe it off on the inside, you can damage it beyond repair. ...
...maf or vac circuit low purge/vac vent valve malfuntion if your purge valve were stuck open it would cause a rich condition because it would constantly be sucking gas fumes from the tank. repair the ...
maf sensor,cap and rotor,sparke pluggs and wires flushed rediator,replaced fuel filter,and took carborater apart and cleaned. carburator was super black and lots of black build up on both sides,also 2
MAF (Mass Air Flow) sensor diode with some throttle body cleaner. the sensor heats up and measures how much it's cooled off by the in coming air flow. if' it's dirty, it's insulated by
MAF (mass airflow sensor), TB (throttle body) carbon build up, intake manifold gasket leaks. Depending on how many miles are on the truck, try replacing the IAC valve. This controls the idle sped at a
MAF but not all the time. Did a standard tune up because it was due anyways. (Plugs, Wires, Air/fuel filters,trans fluid and filter) Fuel Pres Regulator was bad 6 mos ago and was also changed. 5.3l 95
...MAF. If you still have a slight stumble, Then remove the hard plastic tube from the plenum by the throttle body. Start the engie, after it is warmed up, pour water down that hole while revving up the ...
Usually answered in minutes!
4,236 Questions
159 Questions
130 Questions
67 Questions
56 Questions