Questions & Answers for: Subaru remove maf

...throttle body, and spray it also on the throttle plate, and let rest for about 15min. Then refit removed parts, and take the car for a road test till it's all warmed up, most of the time the ...

...MAF, Mass Air Flow sensor. If so, it is a very simple job without the use of special tools. Disconnect wire connection from sensor. Remove air cleaner assembly From the air intake duct. Remove nut ( ...

95 Subaru Legacy loses power at stop lights after the engine gets warm it regains power after hitting the gas peddle a few times but continues to lose power at more stops'' I don't have enough ...

p0130 and p0171 trouble codes showing after cv joint replaced. A code P0171 may mean that one or more of the following has happened: The MAF (Mass Air Flow) Sensor is dirty or faulty. Note: The use of

...for iac (idle air control) iac replaced comp reset still has iac code all vacums checked intake removed checked resealed with new gaskets and comp reset still after all that still throwind cel

...maf sensor was fine at the shop it did jiggle loose though they said and they unplugged it and put it back on and they said it ran fine there. before all this my car would barely speed up unless i ...

...remove and clean the maf sensor. Start with the screw clamp on the intake hose. Then unplug the sensor just squeeze the tab and wiggle it off. Now remove the 4 - 10mm boltsthat hold the maf sensor on ...