...remove the MAF from the rubber air intake hose and spray it all around the inside of the sensor, then try and see if this cures the problem, While at the parts store ask them to show you the MAF and ...
...MAF sensor or IAC (Idle Air Controller). Cleaning any of these only prolongs the inevitable. Change the sensor at fault to eliminate the problem. Have you had the OBD error codes read? Some errors do ...
...there are codes in the TCM of some late model cars where the Transmission control module has been removed from the PCM the vehicles main computer , And basically it happens when the TCM has a issue ...
...MAF cleaner. The sensor is attached to the plastic tub that connects your air filter to your engine. It is screwed in with security torx bits (if I remember correctly), so the easiest way to clean it ...
...code: replaced the spark plugs (porcelain on one was cracked) and the coil-to-plug boots; I've also removed the Air Temp sensor and cleaned it with MAF sensor cleaner. I was about to try and find the ...
...MAF is Throttle Position Correlation.In this error code:--- From the error code P0068 you have its indicating a bad throttle body or throttle actuator controller.. The 2 tps sensors inside read each ...
...( stop light ). 1. Dirty air filter. ( replace ) 2. Idle air control valve. ( sometimes can be removed and cleaned ) 3. MAF, ( mass air flow ), sensor. ( sometimes can be removed and cleaned ) ...
...remove from vechicle. Did the learn procedure for idle. Seems to run ok - but noticed a slight surge in rpm while driving, shifting a bit higher than normal. Also, shifted car into neutral while ...
...remove the MAF sensor "Do no touch the internal sensors. It will ruin it" You can spray the MAF sensor with MAF sensor cleaner and let it air dry (no compressed air, that too will ruin the sensor). ...
Usually answered in minutes!
1,310 Questions
953 Questions
1,183 Questions
963 Questions
862 Questions