...Remove the plastic cover from the engine block. There will be several hoses running between the engine block and the plastic over you just removed. Check those for leaks. (They get hot from being so ...
...a very simple job. Disconnect battery. Disconnect electrical connector to MAF sensor. Remove (unbolt) MAF from air duct. Install new MAF. Reconnect electrical connector. Reconnect battery.
...back on. I blanked off the egr and all the power returned. however the problem soon reappeared so i removed the plate and cleaned and refitted the egr. The light is now on full time, and the car ...
po171 cleaned maf sensor check engine light still on.. How do I clear check engine light? Remove the Negative battery terminal for 1 minute and reconnect, this should reset the stored codes in the ECM
...cleaned. Jaguar uses a SUN cleaning system on the car but it is better if the injectors are removed and sent to a company with an ASNU injector cleaner. These 'Shower Head' injectors seem to ...
...remove the MAP signal wire from the connector. Re-attach the PCM connector and see if with KOEO, the scan tool MAP reading shows voltage. If it still does, replace the PCM. If not, check for voltage ...
...Remove or disconnect the following: Negative battery cable Upper radiator hose Accessory drive belt Water pump pulley Accessory drive belt tensioner Idler pulley Crankshaft damper Engine appearance ...
MAF (Mass air flow) sensor on your vehicle, they are usually equipped with a Barometric pressure reading. If so, the Baro reading should match the MAP reading (they both measure ambient air pressure).
Question about 1999 XK8
MAF Sensor & all intake ducting for vacuum leaks Smoke test intake & manifold, as well as exhaust before cat if you need to If fuel pressure is good & only one bank is rich scope O2 Sensor
Usually answered in minutes!
1,706 Questions
1,411 Questions
907 Questions
707 Questions
655 Questions