Questions & Answers for: Volkswagen Jetta remove lock

...lock itself? you must remove the internal felt covering that is on the inside of the trunk. This does take some force, but don't be afraid to pull hard, you will most likely not break any of the ...

Ad

Question about 2003 Jetta TDI

3 Answers

...lock. What should I do? More than likely the spring inside the latch has come undone. To save some money you can remove the latch from the trunk, open the latch and reset the spring. To Remove the ...

Ad

remove both switch assemblies the lock assembly is secured with a shear bolt you can use a hammer and chissel to tap it around until it can be removed by hand or drill a holein it and use an easy out

Question about 1998 Jetta

1 Answer

...remove the ignition lock cylinder. 1993?99 Golf and Jetta Disconnect the negative battery cable. Center the steering wheel. Remove the air bag. Remove the steering column switches. If the vehicle is ...

Question about 2005 Jetta

1 Answer

...remove the lock. Also a muffler clamp saddle will do if hammered into the locks keyway slot. Then two pipe wrenches are needed to remove the lock that way. One wrench goes onto the muffle saddle and ...

Question about 2003 Jetta TDI

1 Answer

...lock unit, and they are not easy things to replace either. remove the internal door trim. unplugg the wiring inside. remove the outer key barrel and unhook the cable from the outer handle to the lock ...

...remove the Lock Cylinder without the Key? the ignition lock cylinder? No, afraid not. The key has to be turned to a certain position to allow a pin to be pushed into the small hole you can see close ...

Question about 2003 Jetta TDI

1 Answer

lock assy Remove the steering wheel, then remove the steering column covers. Remove the turn signal and wiper switches. Disconnect the ignition switch wiring. On some models, the hole in the lock body

Question about 1997 Jetta

1 Answer

...switch and inspect its connection. If it's ok then check the switch. If both switch and connections are OK then you'll have to remove the door panel and access the

...lock position resulting the key not able to remove and electrical still on IGNITION KEY WILL NOT RELEASE It can be faulty ignition lock cylinder. I suggest to wiggle the steering wheel a bit and see ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...