...remove the ignition module connector terminal 4 is 12 volt supply.4 terminal to the right with lock tab up.connect test light to ground.take the pointed end touch both the terminals for 12 volts with ...
Question about 1999 Yukon
...entry but all other doors works fine. Does anybody know whats wrong. does work with your key if so you remove door panal and lock solniod see if it has power whan useing remote if so replace ...
...remove the lock from the vehicle. Installation is the reverse of removal. When installing the lock, tighten the screws to 89 inch lbs. (10 Nm). Door Lock Switch Remove the door trim panel. Remove the ...
...remove the lock cylinder. To install: Align the marks on the sector gears and install the gears and the backing plate to the lock module assembly. Install the lock cylinder set and ensure that the ...
...lock position and it is stuck. how do i fix this or what do i remove, i have door panel off and was wondering if something if stuck or broken, my key does not want to lock or unlock the door as well, ...
...s side door lock actuator? the symptoms wont lock or did not unlock or flactuating.u need to replace the actuator.remove the door trim of the door remove the metalscrew,remove the linkages of the ...
...lock lever resides.Remove the screw (3) from the opening in front of the armrest.Remove the screw located beneath the map pocket, if equipped.Lift up on door panel to remove from door. Disconnect the ...
Question about 2001 Yukon
...rear wheels or remove the rear drive shaft and lock in the 4wd to derive the front axle you may need to discuss the proposed changes with an accredited transmission shop to get it properly ...
...LOCK switch, or the wires to it. Remove the switch, unhook the wires on it. The switch was either on or off, with wires removed the car thinks its off, so there is a 50% chance the car will think you ...
lock knob. Remove the armrest. Snap off the trim covers and remove the screws retaining the assist strap, if so equipped. Remove the 4 screws securing the lower edge of trim panel. Remove the screw at
Usually answered in minutes!
593 Questions
524 Questions
309 Questions
326 Questions
238 Questions