remove the carb and drill and pry out the covers) Best way to adjust is to set the throttle linkage adjustment screw so that you have the lowest possible idle without stalling and then put a hand held
...lock comes with the switch and key assemply, then there usually a shear bolts. The whole assembly clamps around the steering column, and you tighten bolts until their head shear off, leaving rounded ...
...oil drain, chisel down lock ring,remove nut,remove,locking device,remove second nut.Try to pull it off,If it will not come off you may need to release rear brakes.It should come off easily! Good
remove all the cowlings from the steering column to access the ignition lock and switch. With the correct key inserted and selected to, probably, the ACC position, you should be able to push on either
Remove the lock plate from the shaft. Fig. Fig. 4: Lock lever plate removal Unfasten the 2 retaining screws and lift the lock lever guide plate to expose the lock cylinder release hole. Insert the key
Usually answered in minutes!
143 Questions
145 Questions
63 Questions
53 Questions
51 Questions