Questions & Answers for: Chevrolet Blazer remove lock

Question about 1985 S-10 Blazer

1 Answer

...lock plate and remove it. Unscrew and remove the the hazard knob. Still with me? Good we're almost halfway there. Just kidding Remove the turn signal lever. Remove the canceling cam and turn switch ...

Ad

Remove the lock plate, horn contact carrier, and spring.Remove the bolts at the upper steering column support and the upper mounting bracket from the column.Disconnect the turn signal wiring connector

Ad

Question about 1987 Blazer

1 Answer

...remove the cylinder lock like on a 1976 blazer. turn to accessory and use straight paper clip yo pud pi inside the hole in front of the key while turning key to on and pulling out using key for a ...

...remove lock ring on top of tank pump asm lifts out, remove connection at pump ,use a screw driver and remove screen at bottom of pump,gentle pry bottom holding bracket just enough to sneak pump ...

...remove c lock do same for other side when reinstalling do same push in on axle and reinstall c lock good luck you did remove the retaining bolt correct? it has an 8mm head on it. the only one so you ...

Question about 1999 Blazer

1 Answer

...replace a lock? remove door panel remove linkage remove lock retain clip. use masking tape to cover a flat tiped screw . place tip under door panel gently ,but firmly pull out . screw in door handle

...Remove all burrs in and around lock module assembly (15) and lock cylinder (17). From inside module assembly (15) push on locking tab and pull lock cylinder (17) from lock module assembly (15) and ...

Question about 2001 Blazer

1 Answer

98 Chev Blazer. power lock problem. driver's door would not unlock doors, now it will not lock doors. passenger side works fine you may just have a bad connection under the lock button under switch ...

...Remove the two screws and the switch. To install: Before installation, make sure the switch is in the Lock position. Attach the actuating rod to the switch. Install the switch using the original ...

Question about 1997 Blazer

1 Answer

likely you have a defective power lock actuator inside the door, you will need to remove the door panel and check that the lock actuator is getting a 12 volt signal when you press the lock button

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...