...remove lock cylinder just turn to on position then look under the lock cylinder on the steering column and you will see a small hole,take a pick or small screw driver and stick it into hole to push ...
Question about 1991 Town Car
...lock cylinder to the RUN position. Remove the two screws retaining ignition switch. Disengage the ignition switch from the actuator. Installation Adjust the ignition switch by sliding the carrier to ...
...Remove the ignition switch lock cylinder (11582). Insert the ignition key and turn to the RUN position. Press the ignition switch lock cylinder release pin while pulling out the ignition switch lock ...
...remove lock cylinder. Carefully NOTE: the position of the bearing retainer prior to removal. Remove blue plastic bearing retainer by inserting a screwdriver or similar tool, with a 90 degree bend on ...
...lock housing while depressing the stop tab. To remove the ignition switch, unfasten its securing screws and withdraw the switch from the lock housing. To install: Align the locking cam with the hole ...
...Remove tilt steering column lock lever (if so equipped). Remove lower steering column shroud. Disconnect the ignition switch electrical connector. Rotate ignition switch lock cylinder to the RUN ...
...remove the door lock and take it to a chevy dealer or lock smith and have a couple made. if you have any other ? give us a shout good luck Try this....and I know you don't have the key....but try it. ...
...Remove the anti-lock brake sensor harness from the brake hose clips. Remove the anti-lock brake sensor. Remove the anti-lock brake sensor clip. Remove the anti-lock brake sensor. NOTE: Make sure the ...
Question about 1999 Continental
the main module/box in the drivers door since that's where the sound was coming from when I removed the fuses responsible for door locks, but it still clicked, I also disconnected the electric
Question about 1994 Mark VIII
Remove door lock control bezel. Remove window control bezel. Remove interior lamp lens. Remove screw from interior lamp assembly body. Remove screw from window control bezel opening. Disconnect mirror
Usually answered in minutes!
1,383 Questions
1,094 Questions
900 Questions
898 Questions
893 Questions