Questions & Answers for: GMC Sierra 1500 remove a key tumbler

...remove key , key is new and not worn I had a problem like this - where the key would NOT go to lock when you shifted to PARK an tried to turn off the engine - I fiddled with it for a bit and finally ...

Ad

Question about 2000 New Sierra 1500

1 Answer

...key and tumbler in and now it starts and stays running but the message center keeps showing the Battery and Security light. Now it says I have no gas and wont show what gear its in. I know there is ...

Ad

Question about 2000 New Sierra 1500

1 Answer

...key and tumbler tube is there any way to bypass the security system I think you could but it would be extremely hard and time consuming.All you need to do is take to your local GM dealer for them to ...

key is stuck in the on postion. to turn my truck off i have to dis engage the fuel pump relay and battery cables. how can i fix this either the shift is out of adj or your ignition witch is bad or out

...key tumbler on my 2000 GMC 1500 and now the engine turns over but will not run? did you hook back up the 2 wires for the security system them keys have a chip in them if its not the right key it will ...

the harness out of the column. Turn the lock to Run. If necessary, remove the ignition key. If equipped, remove the buzzer switch assembly. Remove the lock retaining screw and remove the lock cylinder

have had 4 keys cut for my '02 gm x-cab & they fit the door, but don't turn in the ignition very easily. do I need factory gm keys (because of a chip or what?) No, the chip will not cause you not ...

Question about 2004 Sierra 1500 Crew Cab

3 Answers

...key does not activate the contacts correctly, then there is still a power supply being fed. You might be lucky in finding that when you remove the steering housing to view the switch, it may have ...

Question about 2004 Sierra 1500 Crew Cab

1 Answer

...ignition switch[not the key switch],it is on the opposite side of the key switch and has many wires coming from it,some end up at the key switch.A special external torx socket is needed to remove

Question about 2004 Sierra 1500 Crew Cab

1 Answer

...position as instructed with the steering wheel removed remove the KEY CHIME(push in connector w/2 copper wires) there should be a bolt securing key & tumbler removing bolt & pull tumbler ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...