... i think the key tumbler is just worn out. if this is so, how do i remove my tumbler so i can put a new one in? that is best left to a dealer or locksmith many wires inside there get torn off by ...
...Remove the dash housing to give you access to the lock. With the battery disconnected turn the key to the acc position. Look on the side of the lock housing and find the small hole with a little pin ...
key must be in the LOCK position when removing or installing the steering column. Failure to do so may cause the SIR coil assembly to become uncentered and may result in otherwise unneeded SIR repairs
...remove the key from the 99 Buick Regal. Will not crank and can't remove the key from the ignition. Also will not allow me to put it into gear. All these problems hit at once. You need a new ignition ...
remove anything that has a screw in it, hand hold, release lever etc. Once you have done this you will need a large standard screw driver or panel clip tool would be better (its 'u' shaped on the end)
remove broken key from gm ignition lock key is broken off half in cly. Physically removing a piece of an ignition key from the tumbler is practically impossible. The tumbler is filled with spring ...
Question about 2002 Regal
key and need to put the car in neutrual to move it to the drieway not possible with steering and shifter both locked, you can disconnect shift cable from trans and pop it into neutral but that won'
Usually answered in minutes!
757 Questions
631 Questions
489 Questions
420 Questions
426 Questions