Questions & Answers for: Jeep remove glove compartment

...glove box and remove the three screws in the front on the bottom. Take the plastic cover out and you'll see a bank of relays. The horn relay is the one on the far left, closest to you. If they didn't ...

Ad

Question about 2000 Grand Cherokee

1 Answer

...long thanks william Laauwe Your cabin filter on this vehicle should be behind the glove ox, gtly remove your glove bx and you should see the compartment for the filter behind it. Hope this

Ad

Question about 1999 Grand Cherokee

1 Answer

Fan relay switch is stuck on, where is relay switch located Open the glove box, and remove the inner compartment. Here you will find the relay/power distribution box.

...glove compartment won't shut off even when car isn't running. I tried pulling the HVAC fuses and it didn't work. How do I fix this? This is your blower motor fan use the owner manual and locate the ...

Question about 1995 Grand Cherokee

1 Answer

...GLOVE COMPARTMENT!!! YOU HAVE TO REMOVE THE DASH PAD AND THEN THE ENTIRE DASH ASSEMBLY SURROUNDING THE GLOVE BOX SIDE. THIS WAS THE FIRST TIME I HAD TO REMOVE THE DASH PAD AND PANEL BUT IT TRULY WAS ...

Question about 1997 Grand Cherokee

1 Answer

No need to remove glove compartment, but you have to get into an upside down position to locate it. It has two screws that hold it in and a wire harness connector you must disconnect prior to removal

Question about 2005 Liberty

2 Answers

...the slot , the slot helps keep the resistor cool , easy fix less the 10 minutes , best way to help you find it , remove glove , look for a single bolt with a few wires just over the bolt , good ...

Question about 1998 Cherokee

1 Answer

...same model I suspect it is, empty the glove compartment - you will find a panel at the base of the glove compartment, on removal of which you will find a number of relays (including the turn

Question about 2006 Commander

1 Answer

glove compartment. You may need to remove the glovebox to get to it. After you open the glove compartment, you should just have to squeeze the sides inward (a lot) and pull out. The resistor should be

...need to remove the lock cylinder from the glove compartment door and replace. How do I do this??? Here is an answer from fixya. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...