Questions & Answers for: Ford Expedition remove glove box

Question about 1998 Expedition

3 Answers

...remove panels for access to the wiring harness to the ignition switch. STAY AWAY FROM THE HARNESS FOR THE CLOCKSPRING AND AIRBAG. With the ignition on (in run) check for power at the dark blue wire, ...

Ad

...glove box? Look for the plug ends on the new part. The old part is usually recessed in to the housing by the blower and retained by a couple of screws. Find the terminals that match the new part on ...

Ad

...glove box holder i am trying to remove. on the top of your dash you should have an access panel, inside that opening there are three screws that are put in (direction) from front to back, two are ...

...1997 ford expedition we're replacing the heating core and are unable to unhook the passenger airbag, how do I do that. 1st , remove glove box , remember to disconnect negative battery terminal ...

...glove box. Do i need to remove the dash part behind the glove box or it this part under the dash not accessible through the glove box. All I see is the black plastic cover. If I feel way up under the ...

and remove it. your help would be very appreciated ! Thanks, Rlissekam leave the job up to a proffesional these kind of problems can be complicated. but if you must start at glove box then remove dash

Question about 1999 Expedition

1 Answer

HAVE TO REMOVE THE COPLETE DASH ,OR JUST WORK BEHIND THE GLOVE BOX You will have to remove dash to get to heater core, also will need to recover freon from a/c system, evacuate and recharge a/c system

...bolts are always located behind the likes of ur radio, glove box, behind speedo/rev counter, up underneath by the pedal box and stuff like that. dashboards dont drop easily and go back in even

...the two taps on the sides of the glove box the lever is to the left alomost behind the radio but closer to the glove box. if you can't reach it you will have to remove the radio to get to it

Question about 1997 Expedition

1 Answer

...leaking.... pull the right side kick panel off under the glove box. the washer fluid tube cracks behind the panel and it drains into the vehicle. you will need some vacuum tubing to repair the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Expedition
2000 Ford Expedition

2,188 Questions

1999 Ford Expedition
1999 Ford Expedition

1,825 Questions

1998 Ford Expedition
1998 Ford Expedition

1,627 Questions

2003 Ford Expedition
2003 Ford Expedition

1,696 Questions

2001 Ford Expedition
2001 Ford Expedition

1,161 Questions

Manuals & User Guides

Loading...