Question about PC-940 Black and White Copier
Remove 2 *****s securing the fuser. The *****s are located just in front (inside) of the fuser. Disconnect the fuser power cable and logic cables and then rotate the fuser up and toward the exit area.
...remove the fuser. Measure the resistance between the fuser connectors. If it is not within the proper range, replace the fuser. If there is not continuity between the fuser connectors neutral and hot ...
...remove top cover & rear cover ( screws ). The fuser is now visible & there are about 2 or 3 screws on each side that need to be removed before fuser will come out. Large Gear needs to be ...
...remove the fuser. Measure the resistance between the fuser connectors. If it is not within the proper range, replace the fuser. If there is not continuity between the fuser connectors neutral and hot ...
...remove the fuser. Measure the resistance between the fuser connectors. If it is not within the proper range, replace the fuser. If there is not continuity between the fuser connectors neutral and hot ...
remove the fuser unit. You have to remove the 3 front covers of the fuser drawer, remove the three black screws that secure the fuser motor, then the yellow cover to access then two screws that secure
...Fuser 1. Remove the following components: ? Right cover. See Right cover on page 17. ? Right-front cover-1 and cover-2. See Right-front cover-1 and cover-2 on page 20. ? Control panel. See Control ...
...remove the fuser wiper cover 02: Remove the top rear door 03: Open the fuser cover 04: Remove the fuser 05: Remove the new fuser from the packaging 06: Insert the fuser 07: Close the fuser cover 08: ...
...7. fully extend the drawer and push in the leaf springs you see and pull the drawer out further 8. remove the two screws you see on the top of the fuser and remove the fuser unit- gently. Good ...
Question about LASER SHOT LBP 3300 Printer
...remove the fuser on these models; if you don't know how to remove your fuser see the removal instructions farther down this page. Once you have the fuser removed from the printer, look at the barcode ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions