...Remove the ignition key from the ignition lock cylinder. Install the MALL PGM fuse back into the fuse panel. Refer to Electrical Diagnosis in Body and Chassis. Validate that all the ...
...any electrical plugs going to the seat pull out drivers door opening Brackets are broken off welds. Remove two rear torx bolts, tilt seat forward to unclip front, pull seat and re-weld
...and engage it into the latch mechanism and turn this should open the trunk.if not then you will have to remove the rear seat and hope there is enough room to crawl into the trunk to manually open
...drivers side RH first. [2] position opposite end U bar so that the bar tip is inside the desired strength slot. I used the middle slot. [3] Lower the trunk half way. Clamp down the V part of the bar ...
seat removal The drivers electric seat in my 2005 Chevy Malibu Maxx is loose in an up and down direction. It seams like the seat is loose from the tracks it moves back and forth on. Any parts/assembly
Question about 2005 Malibu
Drivers power seat will not move forward from full rear position.how do I access rear bolts to remove seat for repair? all seat switches work I would look real careful under the seat and make sure ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions