Questions & Answers for: remove cpu emachine

CPU if your computer is no longer under warranty, remove the video card (the one where you attach the monitor cable) by the edge gradually off its slot, then put it back in. Test for signal. Make sure

Ad

Question about eMachines Desktop PC

2 Answers

...remove the CPU heatsink clean and reinstall the CPU with the proper contact paste,reinstall the Heatsink along with a new heat sink fan, if that is the one is making noise also. Then see if it will ...

Ad

Question about T2682 (000002965) PC Desktop

1 Answer

emachine t5230 cpu fan too fast wanted to swap in new video card for pci-express to get s-video, decided to clean dust out of computer cabinet, removed cpu not knowing what I was doing, did not know ...

Question about eMachines Desktop PC

3 Answers

...or 6 pin connector) plug 4 pin connector and test power on. if on and off check cpu power section (mosfets) if burned one pls remove ... you can test short by touch the mosfet by finger (burning

Question about eMachines Refurbished EMA SYSTEM BOARD MODEL T2984 eMachines (102257) PC Desktop

1 Answer

Remove the CPU fan and heat sink but PULL UPP CAREFULLY in case CPU stays attached. If cpu is still in socket, carefully lift locking lever and lift cpu straight up. Remove all screws. Board will need

...Emachine T2958, tested power supply (good). Green light on in motherboard when power connected. What's next to ck? Is your PC making any beep sounds, anything at all on monitor? if nothing try ...

Question about eMachines Refurbished EMA SYSTEM BOARD MODEL T2984 eMachines (102257) PC Desktop

1 Answer

...Remove the Heatsink from the CPU and re apply heatsink compound to both the CPU and the heatsink then replace the heatsink onto the CPU. the reason for the overheating and shutdown is that the ...

Question about eMachines Refurbished EMA SYSTEM BOARD MODEL T2984 eMachines (102257) PC Desktop

1 Answer

...STILL GET BEEP. check FAN on CPU. Check also the radiator on the CPU. If you can - remove CPU and check the paste between the CPU and radiator - apply new paste, assemble back the CPU and try

Question about eMachines Desktop PC

1 Answer

...CPU fan to see if it spins freely, if not replace the fan. If the fan and heat sink is clogged with dust the remove the dust and make sure the vents are clear and dust free. Use a small brush and can ...

Question about eMachines Desktop PC

1 Answer

...EMachine 3611 You cannot. See table below. eMachines W3611 RAM Specifications Standard Memory 512 MB (removable) Maximum Memory 2.0 GB Memory Expansion 2 sockets Memory Comments PC2-4200 DDR2 SDRAM ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Computers & Internet Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Computers & Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...