solder and some filing. It continued to work for another 200,000 miles. You can remove the end plate of the solenoid without pulling the starter. Remove the negative battery cable when working on this
...Remove the negative battery first, then the positive (to prevent welding your tools to the car), then clean battery and cables. If that doesn't cure it, you will have to do the other ends of those ...
...Remove the battery positive cable connector eyelet from the solenoid battery terminal stud. Always support the starter motor during this process, do not let the starter motor hang from the wire ...
Question about 1999 Durango
...I had the same problem, i had a new alternator and battery but it still drained it overnight. I removed the light under the hood and its been fine ...
...cover remove it( i personaly would through it away), disconnect the cabels, remove the mount that holds the battery in place, remove the old battery and then reverse all steps only with the new ...
...is a rubber or a plastic hold down which has a single bolt or nut if its on a stud to secure the battery to keep it from moving around. Check to see if there is one and remove it if not let me ...
remove the battery from a 2006 Dodge Durango? One side of that battery will have a single 13 mm bolt that you can loosen and or remove entirely to allow you to remove that battery. Screws located down
battery wire from starter. Loosen & remove the (usually 2) retaining bolts holding starter to engine. Remove starter with a back and down action. To replace just do the opposite. Hope this helps..
...will have to remove and take up there,also take battery,you have a fusible link in line on the positive side of battery,make sure it's not burnt.Here's a link on how to remove your
removal of battery box in 2004 durango the "plastic battery cover" or the entire battery tray?? Plastic battery box
Usually answered in minutes!
2,049 Questions
1,616 Questions
1,378 Questions
886 Questions
1,005 Questions
