Questions & Answers for: Chrysler Sebring how to remove battery

...battery. Remove it by either turning the fasteners 1/4 turn or, if there are push fasteners, pop up the centers of the fasteners and then you can pull out the whole fastener. Disconnect the cables, ...

Ad

Question about 2005 Sebring Conv

1 Answer

...cable remote terminal from the remote battery post. Jack up the left front of the vehicle. Remove the left front wheel from the vehicle. Remove battery splash shield at the front of the wheel

Ad

...you plenty of room to get to the battery. Remove the wheel well plate and you will see the battery just in from of where the tire would normally be pointing. From there it's pretty straight

...Remove the positive battery cable nut and disconnect the cable from the starter. Disconnect the push-on solenoid connector. Remove the lower mounting bolt that attaches the starter to the transaxle. ...

Question about 1997 Sebring

1 Answer

...panel in the front of the wheelwell remove the panel, then remove the battery cable the negative first. The hold down strap should have a 13mm bolt remove the bold a slide the battery out. Good ...

Question about 2004 Sebring

1 Answer

...in front of the front tire. to service the battery or change the battery the drivers front tire is removed and the access panel removed then the battery is visible. disconnect the negative battery ...

Question about 2005 Sebring Conv

2 Answers

...Remove battery splash shield. Disconnect the heater blanket cord, if equipped. Battery Location Remove the left front tire then remove the screws holding the cover, slide cover off, next you will see ...

Question about 2006 Sebring

1 Answer

...Remove battery splash shield. Refer to the Body section of the service manual for the procedure. 5.Disconnect the heater blanket cord, if equipped. Fig. 1 - Battery Location 1 - BATTERY HOLD DOWN 2 - ...

...Remove battery splash shield. Refer to the Body section of the service manual for the procedure. Disconnect the heater blanket cord, if equipped. Remove the short bolt from the battery hold down and ...

Question about 1997 Sebring

3 Answers

...to disconnect from the Battery "NEGATIVE" first and then remove the Battery hold down. Behind front driver side wheel. Remove wheel and skirting under fender. Battery is in a tray towards the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...