Questions & Answers for: Chevrolet Impala how to remove battery

...Remove the battery retainer bolts (1) and retainer (2). With the aid of an assistant, remove the battery. Remove the electrical center cover (1). Disconnect the positive battery cable from junction ...

Ad

would drain the battery if car sat a weak,ending up being the radio shorting inside, dont know if thats your problem but i would start there, dont remove fuse have to remove the radio! hope this helps

Ad

Remove the battery clamp and bolt. Probably a 12mm socket with extension. It's tight, but the battery can be removed. Reverse instructions for installing the battery. (That includes hooking up the red

Question about 2008 Impala

1 Answer

...battery. Remove this bolt that holds the plastic 'hold down' bracket. Use an 8mm or 5/16" hex wrench to undo the negative terminal first, then the positive terminal. Pull out the old battery. ...

...Remove the accessory drive belt. Disconnect the negative battery cable. Disconnect the generator electrical connector. Remove the engine harness terminal from the generator: - Slide the boot back ...

Question about 2006 Impala

4 Answers

...battery. Remove the battery and take to to your local auto parts store to have them check it. i belive your alternator is bad or if there is an additional output of power like a car alarm or even a ...

Question about 2008 Impala

1 Answer

...Fortunately, the 3 bolts on the stabilizer bar are easy to take out. Use a ratchet or wrench to remove the bolts, lift the stabilizer bar out, and pull the battery straight up. Hope this

Question about 2006 Impala

1 Answer

...remove battery and battery tray.step 3.  remove drive belt.step 4.  remove water pump bolts ( 318 ).step 5.  remove water pump ( 300 ) and water pump gasket ( 314 ).discard gasket.step ...

...battery then remove the negative cable from the battery and place a test light between the battery and the cable if the light is on you have a draw remove fuses until the light dims then the fuse you ...

...Remove the underhood fuse block(s) battery cable and buss bar terminals from the fuse block by pulling down. Remove the fuse block and lamp wiring harness from the vehicle, if required. I copied the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...