Questions & Answers for: remove back bumper cover 99

...back in the hole beside the headlight assembly. If you look in with a flashlight You will see 3 bolts down in there. One of them will have a 1/2 inch spacer on it. Do not worry about this bolt, it ...

...back into it in the grocery store parking lot leaving the rear bumper cover broken and the driver's side rear tail light assembly pushed in. There does not appear to be any other damage to the ...

...remove the bumper. Have a blanket or carpet on the ground to protect the bumper. 8. Remove metal clips from tabs that connect the upper bumper cover to the lower bumper cover. 9. Drill out pop-rivets ...

...inside the rear wheel well bolting the bumper to the quarter panel where they meet on the side. There might be a clip under each tail light.Then remove the plastic clips and slide it straight

...remove the front bumper cover. Put the car on jack stands (the front) and remove the inner fender plastic. You'll need a long extension and a 10mm socket to remove the nuts and bolts holding the ...

location of horn for a 99 ford escort zx2 You have to remove the front bumper cover to gain access to the horn. It is below the passenger side headlight.

...back and remove retainer inside that goes through the bumper into the fender-next remove the retainers across the bottom of the bumper cover-you should be able to pull it off-watch out for wires ...

...back, supporting both sides with jack stands, and remove the rear wheels. Using Torx Bits, remove the inner rear wheel well lining. Get behind the rear wheel well and loosen the bolts holding the ...

...with the list of parts for the front bumper cover of a 99 n15 nissan pulsar plus hi jack. see if this link helps you out. parts diagram for the front bumper cover of 99 n15 nissan pulsar

...Remove the screws or fasteners securing the license plate assembly, and detach it from the bumper cover. 8. **Install the New License Plate Assembly:** - Attach the new license plate assembly to the ...