Questions & Answers for: remove air intake manifold 2007

...caliber's battery? remove air cleaner intake tube(2 thumb retainers) and air filter box . remove batt hold down in front of batt and nev.cable then positive cable last. reinstall in reverse

2007 2.0L dodge caliber? Hello Maurice. The sensor on your Caliber is below the exhaust manifold and a little to the left center of the engine block. In the diagram it is picking up it's signal direct

...REMOVE THE AIR INTAKE ASSEMBLY.REMOVE THE STARTER MOUNTING BOLTS.DISCONNECT THE THROTTLE BODY ELECTRICAL CONNECTOR. REMOVE THE THROTTLE BODY.PUSH THE STARTER UNDER THE INTAKE MANIFOLD.TIP THE NOSE OF ...

...engine light P2006-intake Manifold Runner Control Stuck Closed Hope that helps. iam working on a dodge caliber 2007 has p2006 and making a noise sound like it is comin from the intake maniflod ...

were is throttle body on 2007 dodge caliber Fallow the air intake tube back to the engine and at the end of the tube will be the throttle body.

...a code P2017 on a 2007 Dodge Caliber? Engine light is on, Code reads 2017 & 2004. What does it mean? How can I repair it? p2017 is a intake manifold runner position switch or sensor high bank

...intake manifold air control actuator , bank 1 --actuator stuck open====causes ---wiring---intake manifold air control actuator ---mechanical fault second reference is intake manifold air control ...

...intake manifold air control actuator , bank 1---actuator stuck open or for second case --solenoid stuck open====causes --wiring---intake manifold air control actuator---intake manifold air actuator ...

...intake manifold air control actuator, bank 1--actuator stuck open===-causes --wiring--intake manifold air control actuator---mechanical fault at this point have the actuator checked for correct ...

...intake manifold . Reset procedure to fix the dodge caliber throttle motor, you turn the vehicle on but do not start the engine. the accelerator pedal is fully depressed for 10 seconds. at this stage, ...